ESPRIT 646 Manual de instalación descargar pdf (Pagina 10)

6 Reference & Installation Manual

Disabling 642 Keypad Zones:

If the keypad zone input terminal is not being used, disable it by shorting the ZONE and COM terminals of the keypad with a 1KW

resistor.

Once the keypad zones have been defined you must enable "Keypad Zone Supervision" (see section 7.13 & 7.14) in the control

panel. Figures 8 and 9 demonstrate typical keypad zone input installations.

Table 2: Keypad Zone Recognition

If using an LED keypad simply set the Zone Select Jumper at the back of the keypad:

Zone Select Jumper "OFF" = Keypad Zone 1

Zone Select Jumper "ON" = Keypad Zone 2

Note: If the zone select jumper is changed, the control panel will only recognize the change

when the keypad is disconnected and re-connected.

If using an LCD keypad with ATZ disabled, program the keypad definition as follows:

Keypad Programming Mode, option [2] (Keypad Options); Key [3] OFF = Keypad Zone 1

Keypad Programming Mode, option [2] (Keypad Options); Key [3] ON = Keypad Zone 2

The control panel will display open keypad zones as follows:

Kpd Zone 1 = Zone [13]

Kpd Zone 2 = Zone [14]

Note: When the ATZ feature is enabled in the control panel, it will not be able to distinguish

between zone 13 and keypad zone 1 and between zone 14 and keypad zone 2

(see section 2.10)

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 55 56

Sin comentarios

ESPRIT 646 Manual de instalación Pagina 10